Features

1. High adhesive strength, Improve overall masonry strength and load bearing capacity.
2. Excellent bonding and waterproofing.
3. Pre-mixed and ready to use, only water is to be added at site.
4. No water curing is required after application, so plastering just after 24 hours of application.
5. Easy to mix and easy to use. Reduces labor cost.
6. Economical – quantity of mortar is far less than conventional mortar.

Area of Application

1. Laying and jointing of masonry, AAC blocks, fly ash bricks, and hollow blocks.
2. Jointing of pre-stressed concrete slabs, panels.
3. Jointing of concrete window and door frames.

Surface Preparation

1. The base surface should be properly cured prior to application of joining mortar.
2. The surface must be cleaned thoroughly, with no loose particles or dust.
3. The surface must be structurally sound, clean and free from dirt, oil, grease, efflorescence and any other contaminant which could impair the natural bond.
4. Surface defects such as cracks, holes or voids should be repaired prior to application.
5. It is very important to pre-wet the blocks/bricks before the same is taken up for joining application with Cetfix BLA for best results and durability.

Mixing

1. Mix 3 parts Cetfix BLA and 1 part of water by volume to stiff consistency. Leave for 5-minute, remix and use within 45 minutes.

Application Process

1. Apply a thin uniform layer of Cetfix BLA 3 to 4 mm thick, on the levelled surface of masonry units using proper trowel.
2. Place the next course of masonry units on the evenly laid jointing mortar bed in proper line & level.
3. Clean the excess material, if any immediately, continue the procedure for the entire masonry works.

Coverage

1. 40 to 50sqft per 40 kg bag at 6 mm bedding thickness.

Packing

1. 40 kg bag

Shelf Life

1. 12 months